I have a very small but annoying dent above my rear fender. i would like to pull or push it out but would like to know if anybody on the forum has addressed a similar issue.
I believe the aluminum is quite thick as I measured 3mm in a few spots using a micrometer. I'm not sure the 'painless dent' pulling is going to work here.
However, getting to the backside of the body in that area is a real challenge.
Before I move ahead, I'd like some advice.
Thank you
Scott
Be carefull that the paint does not lift off when you pull ... I had this issue with the Giannini. Best is to bring it to a pro. Warm regards, Renald.